3NLED lighting

MON-FRI 9:00 AM-6:00 PM GMT -4

sales@3nled.com

Contact Us

Add:10th Floor,Building 3rd,Industrial Building,Heshuikou Park,Gongming Town,Shenzhen,China

E-mail:sales@3nled.com

Tel:+86-755-27516500

How to install LED tube light

Home >  News > LED News
Date:2014-10-27
Note: must be installed by the certified electrician or electrical engineer to (install the product) when installation, please read the following instructions. Before installation, please check the LED tube in the transport process is damaged. If all the intact please install LED lamp according to the following steps.
 
Methods / procedures
 
Disconnect the power supply, check the fluorescent lamp inductance ballast or is your electronic ballast. The hypothesis is stent inductance type ballast, installation as shown below from the starter and ballast, as shown in the diagram to change the stent wire connection and good insulation treatment, and then loaded on LED Tube Light.
 
Inductance type ballast bracket modification plan
                  LED tube light Install
 
If support of electronic ballast, installation as shown below from the starter and ballast, as shown in the diagram to change the stent wire connection and good insulation treatment, and then loaded on LED tube light.
 
The matters needing attention
 
In order to ensure that the lighting installation, repair, check the normal work. Please entrust electrical professionals, non professional construction dangerous.
 
Please according to rated voltage on the packaging or on the fixtureinstallation use, do not use the voltage is too high or too low state,otherwise easily lead to product failure.
 
Installation and replacement of lamp before, must first cut off the power supply
 
LED fluorescent lamp should not be used directly as a dimmingcontrol, sensor function.
 
LED fluorescent lamp can not be used for optical instruments directviewing, grade 1M
 
Do not install the stove, gas and exhaust above, wet places andmore than 50 places, to avoid damage.
 
LED fluorescent lamp in the electrical connection wire, high voltagewire must be connected by electrical switch controller to control the lamp off contact, otherwise easily lead to product failure.
 
Please keep safe wiring specification.

Keywords for the information: How to install LED tube light

Copyright © 2014-2015,3NLED Lighting Co., Ltd All Rights Reserved. 粤ICP备14005063号